Options:
|
TT4 Specification:
- 18 - 35 Watt Class A Acoustic/Harp/Pedal Steel Amplifier (and all points in between!)
- NEW! Super cool bronze control plate adding vibrant contrast to the theme of the amp
- Sheldon 6V6 or 6L6 tubes available as standard
- Pre-amp uses 12AX7's on all models
- Simple 'uncluttered' classic pre-amp design, using a minimum number of gain stages to optimize true tone and reduce inherent noise levels
- Tone controls designed to give a wide range of control over tone settings
- DC stand - off heaters on valve filaments to reduce hum
- Special filter circuitry in power supply to reduce rectifier diode switching noise and thus reduce RF noise. This improves the amp response very subtly
- Combines small amount of cathode bias with fixed bias to provide compression when being run hard. This smoothes out the response and rounds out the tone when flat out
- Point to point hand wired using circuit card and eyelet construction on 3.5 thick blue board for robust build quality and easy future maintenance
- Bronze covering as standard
No PCB’s of any description.
|