Options:
|
TT2 Specification:
- An 18 Watt Class A to 35 Watt Class AB push-pull Amplifier (and all points in between!).
- Sheldon EL84 or EL34 tubes as standard.
- Pre-amp uses 12AX7's on all models.
- Simple 'uncluttered' classic pre-amp design, using a minimum number of gain stages to optimize true guitar tone and reduce inherent noise levels.
- Tone controls designed to give a wide range of control over tone settings.
- DC stand - off heaters on valve filaments to reduce hum.
- Special filter circuitry in the power supply to reduce rectifier diode switching noise and thus reduce RF noise. This improves the amp response very subtly.
- Combines a small amount of cathode bias with a fixed bias to provide compression when being run hard. This smoothes out the response and rounds out the tone when flat out.
- Point to point hand wired using circuit card and eyelet construction on 3.5 thick blue board for robust build quality and easy future maintenance.
- Red, Ivory and Black covering as standard.
No PCB’s of any description.
|